Liqua-Fil - Case of 4 gallons

Crack and Expansion Joint Filler

Item #125590

Liqua-Fil - Case of 4 gallons

Crack and Expansion Joint Filler

Item #125590

Options:

Need Assistance? Call us 1-800-321-8180

Favorite Share

Ready-to-use formula
Seals out water
Expands and contracts as needed

Product Description

State’s Liqua-Fil prevents crumbling surfaces when used to seal cracks in blacktop, asphalt or concrete. Used soon enough, Liqua-Fil prevents future chuckholes. Easily applied, Liqua-Fil can help avoid costly repairs to vehicles caused by broken paved areas. State’s Liqua-Fil comes in a one gallon container with a convenient pour spout cap. No mixing or heating is required. Maintenance repairs can be made on the spot.

SPECIALLY FORMULATED
State’s Liqua-Fil is formulated to fill the deepest part of the crack before it sets up. This ensures that the seal will hold through all types of weather.

The expansion and contraction of freezing and thawing water in paved surfaces can cause the surface to crack and crumble. State’s Liqua-Fil prevents water penetration into a sealed crack to fight freeze-thaw damage and avoid further cracking.

USE INDOOR OR OUTDOOR
Repair any concrete, blacktop or asphalt surface in minutes: inside or outside of warehouses, factories, shipping and receiving dock areas, parking lots and garages; any area that can be damaged by cracks from heavy traffic or temperature changes.

Directions for Use

Clean dirt and loose material from crack with a brush, water hose or air pressure. Dampen surface slightly but avoid leaving any standing water in crack when applying State’s Liqua-Fil. Do not apply at temperatures below 50° F or if rain is forecasted. Turn container over several times to mix contents. Place pour spout cap on gallon container and snip off top of spout to width of crack to be filled or as desired. Pour State’s Liqua-Fil into crack, pressing sides for even flow. Fill crack to a level slightly below adjacent surfaces. DO NOT OVERFILL. Allow to set up. To keep from cracking, spread sand over surface. For extra deep cracks, fill first with sand to within one half inch of surface or apply State’s Liqua-Fil in two applications. The first application to within one-half inch of surface, then apply second application after the first has hardened. For immediate cleanup, wash tools with water. To remove dried State’s Liqua-Fil, wash tools with State’s SSD® II.